Winston EAGLE V42-DD Instructions d'exploitation télécharger pdf (Page 4)

Fig. #3

Checking The Control Box Plugs

Each connector is "keyed" or "indexed" for proper alignment when attached.

The drive motor plug should be securely connected to the lower outlet on the left side of the control

box.

-4-

Drive Motor

connection

Speed Control

Knob

Main Power Input

30A 250V (L6-30)Twist-Lock Plug Furnished

II. OPERATION

A. POSITIONING OF WELDER

(For modified Bitumens APP or SBS)

The pressure roller should be positioned so that it

rolls fully on the surface of the top sheet, about 1/4"

inside the edge of the shelf. The edge of the roller

should not hang over the edge to keep it from

picking up the liquefied asphalt. (See Fig. #4).

THREADING THE HANDLE.

Thread the handle to the back of the welder. Tighten down the locking bolt so that the handle is firmly

bolted to the unit.

Put gear lever to drive to move the welder.

(CAUTION) - Lifting the welder by the lever can break off the lever.

Fig. #4

Drive Motor

Lever

Main Power

Switch

AC Input

Voltage

Indicator

Handle

COMPRESSION

WHEEL

0.25"

Bleed-Out

1 2 3 4 5 6 7 8 9 ... 12 13

Pas de commentaire

Winston EAGLE V42-DD Instructions d'exploitation Page 4